The ultimate flagship of Wilesco steam engines, with a a twin cylinder aggregate, the Wilesco D32 is the biggest one they made. These beautiful machines were made from the mid 1950s until 1982 which make them hard to find and expensive. But most model steam engine collectors are willing to cough up the price without hesitation. Some are even willing to sell a couple from their precious collection just to obtain this one. Look at the faces of these boys in the picture playing with one... Yes, I want one as well!
NEW: Return of a legend. After more than 40 years Wilesco will produce a limited edition of their famous machine!
Instruction manual: Looking for the English manual? I've emailed Wilesco and got the instructions. You can download the manual here: Wilesco D32 manual (PDF).
The big boiler holds one liter of water and is electrically heated (2 heaters of 750w) because of the size. The engine of the Wilesco D32 has 2x double acting pistons and has 2x 100mm. fly wheel size. The two cylinders each have a 13mm. bore and 16mm. stroke and are the same as in a D16, D18, D20, D21, D24 and D28. It's important to have water in the tray before running the engine for the water pump to continually feed the boiler.
The brass boiler ( dia. = 10 cm, length = 23 cm, volume approximately 1000 cm3.) is brazed, the nickel plated housing embracing it is also made of brass and contributes to better thermal insulation.
The flywheels are made of die-cast aluminium. The coupling between the drive shafts is by a universal joint so that allowances are made for slight mechanical misalignment. Wilesco D32's cylinders, pistons, steam chest, as well as slide rods are precision turned parts made of brass with a honed finish.
The exhaust/condensed water is passed to the chimney-base giving the effect of smoke, any condensed water collected is returned to the sump on the left of the control panel via an outlet in the chimney base. The Wilesco D32 model steam engine should never be operated without the chimney. The condensed water sump has to be drained regularly and it is advisable to clean it after every run.
The valve on the feed water pump hat two extreme positions. When the valve is opened (anti-clockwise or idle running) the feed water pump will pump the water out of the sump and return it immediately. This process can be checked by the water flowing from the pump return pipe which is by the sump opening. When the valve is closed (clockwise = pumping) the feed water pump will pump water from the sump into the boiler. At an intermediate position of the valve it is possible to replace only as much water into the boiler as that being consumed. However, it must at all times be at least a quarter full. This rule must always be observed.
Should it be necessary to drain the reservoir, the feed pump valve has to be in the pump (clockwise position) and the water-valve, to be found adjacent to the feed water pump, must be opened (anti-clockwise). Make sure that a water basin has been but below the waste pipe which is behind the feed water pump. The pump of the Wilesco D32 has to be regularly greased. Due to the type of valve fitted in the feed water pump, the knocking noise is unavoidable.
The Wilesco D32 has electrical heating and is performed by a heating element which is below the brazed brass boiler. An over-temperature fuse has been installed for safety reasons which blows whenever the engine is heated without water. In case of breakdown of the electrical heater, make certain that the power supply is disconnected by switching the power off at the mains and remove the plug from the supply socket.
The D32 has the following features, taken from the manual: